Home / Applications / Insulation and HVAC
Insulation and HVAC adhesives
Hot Melt Adhesive for Insulation and HVAC Assembly
9761 is Cattie's hot melt for insulation and HVAC. It sets as it cools, so facings, duct wrap and equipment parts move to the next station sooner, with no solvent and no dryer.
Featured grade: 9761
9761 is a hot melt for insulation and HVAC assembly. It is not a pressure-sensitive adhesive. It is applied molten and sets as it cools, building its bond in seconds without solvent, flash-off or a drying oven.
- Sets as it cools, so parts can be handled sooner
- Solvent-free, with no dryer or flash-off
- Used on facings, fibrous insulation, foams and HVAC parts
- Matched to your melter, applicator and line speed
Stock grades
Insulation and HVAC
| Product number | Type | Typical use |
|---|---|---|
| 9761 | Hot melt (not pressure-sensitive) | Insulation facings, duct wrap and HVAC assembly |
Typical values, not specifications. Test for your application. Call 800-249-0337 for the TDS and SDS.
Product numbers are starting points. Ask for the TDS and SDS, and for documentation for your application.
Where it runs
- Tacking facings to fiberglass and mineral wool
- Closing seams on duct wrap
- Bonding parts in air handlers, filter frames and equipment housings
Run tips
Apply to the denser surface when you can, and close the bond fast. Fibrous insulation pulls heat out of the bead, so a larger bead or a faster close usually works better than raising tank temperature. Test bonds at the service temperature the part will see, and tell us about heat near the bond line so we can check the grade.
Bonding insulation or HVAC parts now? Tell us the insulation, facing and part, and we'll quote a grade.
Call 800-249-0337 Request a quote
Send us the grade you run now and we'll match it.
FAQ
What hot melt is used for insulation and HVAC?
Cattie's grade is 9761, a hot melt for insulation facings, duct wrap and HVAC assembly. It sets as it cools, with no solvent and no dryer.
Is 9761 a pressure-sensitive adhesive?
No. 9761 is not pressure-sensitive. It is applied molten and sets as it cools to form the bond.
Do I need a solvent adhesive for insulation?
Often not. Hot melt is solvent-free and sets as it cools, with no flash-off. Tell us your line and we'll check the fit.
Can you match the insulation adhesive I run now?
Yes. Send us the grade you run now, the insulation, the facing and your applicator, and we'll match it and quote it.